ES 725

ES 725 Battery/Starting/Charging Tester User Manual

Model: 725

1. Giriş

This manual provides detailed instructions for the safe and effective operation of the ES 725 Battery/Starting/Charging Tester. The ES 725 is designed to test 6 and 12-volt batteries, as well as 12 and 24-volt charging systems. It performs a guided test sequence covering battery condition, cranking volts, and the overall charging system, including alternator voltage and AC ripple for bad diodes.

2. Təhlükəsizlik Məlumatı

Always observe the following safety precautions when using the ES 725 Tester:

  • Wear appropriate eye protection (safety glasses) and protective clothing.
  • Ensure adequate ventilation when working with batteries, as they can produce explosive gases.
  • Avoid sparks or open flames near batteries.
  • Cərəyan edən elektrik komponentlərinə toxunmayın.
  • Keep the tester dry and clean. Do not expose it to rain or moisture.
  • Refer to the vehicle manufacturer's service manual for specific safety procedures related to the vehicle's electrical system.

3. Paketin məzmunu

Bütün əşyaların paketdə olduğunu yoxlayın:

  • ES 725 Battery/Starting/Charging Tester unit
  • İstifadəçi Təlimatı (bu sənəd)
  • Test leads with clamps

4. Məhsulun xüsusiyyətləri

The ES 725 Tester offers the following key features:

  • Tests battery condition and the starting/charging system.
  • Battery test results include State of Health percentage, State of Charge percentage, and actual CCA capacity.
  • Removes surface charge prior to battery test for accurate results.
  • 2-line LCD display available in 7 languages.
  • CCA test range: 40 - 2000 CCA.
  • Tests 6V and 12V batteries.
  • 12V və 24V şarj sistemlərini sınaqdan keçirir.

5. Quraşdırma

Before operating the ES 725 Tester, ensure it is properly set up:

  1. Güc mənbəyi: The unit is battery-powered. Ensure a fresh 9-volt battery is installed in the designated compartment.
  2. Connect Test Leads: Qırmızı cl əlavə edinamp müsbət (+) batareya terminalına və qara clamp mənfi (-) batareya terminalına. Təhlükəsiz əlaqəni təmin edin.
  3. İlkin Ekran: The LCD will power on and display the initial menu.

6. Əməliyyat Təlimatları

The ES 725 provides a guided test sequence. Follow the on-screen prompts.

6.1. Batareya Testi

  1. Connect the tester to the battery terminals as described in the Setup section.
  2. Select "Battery Test" from the main menu using the navigation buttons.
  3. Batareyanın Soyuq Əyilmə rejimini daxil edin Amps (CCA) rating when prompted. This information is typically found on the battery label.
  4. The tester will automatically remove surface charge and perform the test.
  5. Results will display State of Health (SOH), State of Charge (SOC), and actual CCA capacity.

6.2. Cranking Volts Test

  1. Ensure the tester is connected to the battery.
  2. Select "Cranking Volts Test" from the menu.
  3. Follow the on-screen instructions to crank the engine for a short period (typically 5-10 seconds). Do not start the engine.
  4. Test cihazı həcmi ölçəcəktage drop during cranking and display the results, indicating the starter's performance.

6.3. Şarj Sistemi Testi

  1. With the tester connected, select "Charging System Test."
  2. Start the vehicle's engine and allow it to idle.
  3. The tester will measure the alternator's output voltage and check for AC ripple, which can indicate faulty diodes.
  4. Follow any additional on-screen prompts, such as increasing engine RPM, if requested by the tester.
  5. The results will indicate the health of the charging system.

7. Baxım

To ensure the longevity and accuracy of your ES 725 Tester:

  • Təmizləmə: Cihazı yumşaq, quru bir parça ilə silin. Aşındırıcı təmizləyicilərdən və ya həlledicilərdən istifadə etməyin.
  • Yaddaş: Test cihazını sərin, quru yerdə, birbaşa günəş işığından və həddindən artıq temperaturdan uzaq saxlayın.
  • Batareyanın dəyişdirilməsi: Replace the internal 9-volt battery when the low battery indicator appears on the display.
  • Lead Inspection: Periodically inspect the test leads and clamps for damage. Replace if any wear or damage is observed.

8. Giderme

ProblemMümkün SəbəbHəll
Test cihazı işə düşmür.Dead or improperly installed 9V battery.Replace the 9V battery or ensure it is correctly installed.
Qeyri-dəqiq test nəticələri.Poor connection to battery terminals; incorrect CCA input; battery surface charge not removed.Əmin olunamps are clean and securely attached. Verify correct CCA input. The tester automatically removes surface charge, but ensure battery has rested for a few minutes if recently charged.
Ekranda "Xəta" mesajı.Batareya həcmitage too low; connection issue; internal fault.Batareyanın həcmini yoxlayıntage (if extremely low, tester may not function). Re-check connections. If problem persists, contact support.

9. Spesifikasiyalar

  • Model: 725
  • Batareya həcmitage Uyğunluq: 6V, 12V
  • Şarj Sisteminin Həcmitage Uyğunluq: 12V, 24V
  • CCA Test Range: 40 - 2000 CCA
  • Ekran: 2 xəttli LCD
  • Güc mənbəyi: 9 volt batareya
  • Ölçülər (U x G x Y): 27.9 x 25.4 x 7.6 sm (təxminən)
  • Çəki: 771 g (təxminən)

10. Zəmanət və Dəstək

Zəmanət məlumatı və ya texniki dəstək üçün istehsalçının rəsmisinə müraciət edin websaytına daxil olun və ya müştəri xidməti şöbəsi ilə əlaqə saxlayın. Satınalma qəbzini alışın sübutu olaraq saxlayın.

İstehsalçı: Elektron ixtisaslar

Brend: ES

Model: 725

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.