1. Giriş
This manual provides comprehensive instructions for the proper setup, operation, and maintenance of your Compustar 700R replacement remote for remote starter systems. Please read this manual thoroughly before attempting to use or program your new remote to ensure correct functionality and to avoid potential issues.
The Compustar 700R is designed as a direct replacement for compatible Compustar remote starter systems, offering reliable control over your vehicle's remote start, lock, unlock, and other auxiliary functions.
Image: The Compustar 700R replacement remote, a compact black device with multiple control buttons for vehicle functions.
2. Təhlükəsizlik Məlumatı
- Pultu sudan və həddindən artıq nəmdən uzaq tutun.
- Avoid exposing the remote to extreme temperatures (hot or cold).
- Pultu sökməyə və ya dəyişdirməyə çalışmayın. Bu, zəmanəti ləğv edə və zədələnməyə səbəb ola bilər.
- İşlənmiş batareyaları yerli qaydalara uyğun olaraq atın. Batareyaları yandırmayın.
- Batareyaları uşaqların əli çatmayan yerdə saxlayın. Udulduqda dərhal həkimə müraciət edin.
3. Paketin məzmunu
Paketinizdə aşağıdakı elementlərin olduğunu yoxlayın:
- Compustar 700R Replacement Remote (1 unit)
- Lithium Metal Battery (pre-installed or separate, typically 1 unit)
If any items are missing or damaged, please contact your retailer or Compustar support.
4. Quraşdırma
4.1 Batareyanın quraşdırılması
The Compustar 700R remote typically comes with a pre-installed battery. If you need to install or replace the battery, follow these steps:
- Pultun arxasındakı batareya bölməsinin qapağını tapın.
- Carefully open the cover using a small coin or screwdriver if necessary.
- Insert the new Lithium Metal battery (e.g., CR2032) with the positive (+) side facing up, observing the polarity markings inside the compartment.
- Batareya bölməsinin qapağını etibarlı şəkildə bağlayın.
4.2 Programming the Remote
The 700R remote must be programmed to your vehicle's Compustar remote starter system to function. The programming procedure can vary slightly depending on your specific Compustar system and vehicle model. Always refer to your vehicle's remote starter system manual for the most accurate programming instructions. A common programming method involves the following general steps:
- Locate the Valet Switch: Find the Valet switch in your vehicle. This is usually a small button located near the steering column, under the dash, or in the fuse box area.
- Proqramlaşdırma rejiminə daxil olun:
- Insert your vehicle's key into the ignition.
- Turn the ignition to the ON position (do not start the engine).
- Within 5 seconds, press and release the Valet switch 5 times. The vehicle's parking lights should flash, or the horn may chirp, indicating entry into programming mode.
- Pultu proqramlaşdırın:
- While the system is in programming mode, press and hold the Kilidləyin button (or the primary function button) on your new 700R remote for approximately 2 seconds.
- The vehicle's parking lights should flash again, or the horn may chirp, confirming that the remote has been programmed.
- Proqramlaşdırma rejimindən çıxın: Turn the ignition OFF. The system will automatically exit programming mode after a few seconds of inactivity.
- Pultu sınayın: Test all functions of the remote (lock, unlock, remote start) to ensure successful programming.
Qeyd: If you are programming multiple remotes, program them one after another without exiting programming mode. If an existing remote stops working after programming a new one, you may need to re-program all remotes simultaneously.
5. işlək
The Compustar 700R remote provides control over various vehicle functions. Button labels and functions may vary slightly based on your specific Compustar system configuration.
- Kilid düyməsi: Press once to lock the vehicle doors.
- Kilidi Açma Düyməsi: Press once to unlock the vehicle doors.
- Uzaqdan Başlama Düyməsi: Press and hold for approximately 2-3 seconds to initiate remote engine start. The vehicle's parking lights will flash, and the engine will start.
- Remote Stop Button: While the engine is running via remote start, press and hold the Remote Start button again for 2-3 seconds to turn off the engine.
- Trunk Release / Auxiliary Button: Press and hold for approximately 2-3 seconds to open the trunk or activate a programmed auxiliary function (e.g., power sliding doors).
- Panic / Car Finder Button: Press and hold for approximately 2-3 seconds to activate the vehicle's alarm (panic mode) or to locate your vehicle in a parking lot (car finder). Press any button to deactivate.
Refer to your Compustar system's main user manual for detailed information on specific button combinations and advanced features.
6. Baxım
6.1 Batareyanın dəyişdirilməsi
When the remote's range decreases or it becomes unresponsive, it may be time to replace the battery. Follow the steps outlined in Section 4.1 Battery Installation. The 700R remote uses one Lithium Metal battery (e.g., CR2032).
6.2 Təmizləmə
To clean the remote, wipe it gently with a soft, dry cloth. Do not use harsh chemicals, abrasive cleaners, or immerse the remote in water.
6.3 Saxlama
Pultu uzun müddət istifadə edilmədikdə, birbaşa günəş işığından və həddindən artıq temperaturdan uzaq, sərin və quru yerdə saxlayın.
7. Giderme
| Problem | Mümkün Səbəb | Həll |
|---|---|---|
| Remote not responding / No functions work | Ölü və ya zəif batareya Pult əhatə dairəsindən kənardadır Uzaqdan proqramlaşdırılmamışdır |
Batareyanı dəyişdirin (Bölmə 4.1) Avtomobilə yaxınlaşın Re-program the remote (Section 4.2) |
| Qısa əməliyyat diapazonu | Aşağı batareya Ətraf mühitə müdaxilə Obstructions between remote and vehicle |
Batareyanı dəyişdirin (Bölmə 4.1) Move away from sources of interference (e.g., power lines, large metal structures) Ensure clear line of sight if possible |
| Vehicle does not remote start | Vehicle conditions not met (e.g., hood open, door ajar, low fuel) Pult düzgün proqramlaşdırılmayıb |
Check vehicle status indicators Ensure vehicle is in 'ready mode' for remote start Re-program the remote (Section 4.2) |
| Existing remote stopped working after programming new one | System exited programming mode before all remotes were programmed | Re-program all remotes (old and new) in a single programming session (Section 4.2) |
If you continue to experience issues after attempting these troubleshooting steps, please contact Compustar customer support or an authorized dealer.
8. Spesifikasiyalar
- Model: 700R
- Maddə çəkisi: 0.96 unsiya
- Paket Ölçüləri: 4.65 x 2.72 x 0.59 düym
- Batareyalar: 1 Litium Metal batareya tələb olunur (daxildir)
- İstehsalçı Hissə nömrəsi: 700R
- Xüsusi Xüsusiyyət: Erqonomik dizayn
- Bağlantı texnologiyası: Infrared (Note: Some Compustar systems use RF, verify compatibility with your system)
- Rəng: Qara
9. Zəmanət və Dəstək
For detailed warranty information regarding your Compustar 700R replacement remote, please refer to the official Compustar website or the warranty card included with your original remote starter system. Warranty terms typically cover manufacturing defects for a specified period from the date of purchase.
If you require technical assistance, have questions about programming, or need to report a defect, please contact Compustar customer support through their official website or consult an authorized Compustar dealer. Providing your product model (700R) and any relevant system information will help expedite support.
Onlayn Resurslar: Visit the official Compustar website for FAQs, updated manuals, and support contact information.
