Dynamic-Biosensors-logo

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

Spesifikasiyalar

  • Məhsulun adı: heliX cyto Normalization Solution (Red Dye)
  • Sifariş nömrəsi: NOR-R2
  • Qırmızı kanalda scIC ölçmələri üçün
  • Yalnız tədqiqat istifadəsi üçün
  • Məhdud saxlama müddəti - lütfən, etiketdəki son istifadə tarixini yoxlayın

Əsas Xüsusiyyətlər

  • HeliXcyto çipinin 1-ci və 2-ci nöqtəsində flüoresan siqnalların normallaşdırılması üçün
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

Məhsul təsviri

  • Sifariş nömrəsi: NOR-R2

Cədvəl 1. Məzmun və Saxlama Məlumatı

Material Cap Konsentrasiya Məbləğ Saxlama
Normallaşdırma həlli-R2 Qırmızı 10 µM 6x 100 µL -20°C
  • Yalnız tədqiqat istifadəsi üçün.
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

Hazırlıq

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4Etiketli analit məhlulunda boyanın konsentrasiyası
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

Seyreltilmiş məhlullar 2-8°C temperaturda 7 günə qədər saxlanıla bilər.

Tətbiq Qeydi
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    Flüorofor konsentrasiyası ölçmədə istifadə olunan analitin konsentrasiyasına, həmçinin analitin etiketlənmə dərəcəsindən asılıdır. Yüksək DOL və yüksək analit konsentrasiyaları üçün həyəcanlanma gücünün azaldılması tələb oluna bilər.
  • Gözlənilən bağlama siqnalı
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • Çip növü
    Fərqli çip növləri müxtəlif flüoresan fonlara malikdir. Tələlər nə qədər böyükdürsə və çipdə nə qədər çox tələ varsa, fon siqnalı bir o qədər yüksəkdir. Buna görə də, L5 çipləri M5 çiplərinə tətbiq olunandan daha az həyəcan gücü tələb edə bilər.

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 M5 çipi

Analit boya konsentrasiyası. = analit konsentrasiyası x DOL Həyəcan gücü Konsentrasiyanın normallaşdırılması məhlulu Seyreltmə Normallaşdırma məhlulu
25 nM 0.5 25 nM 1:400
50 nM 0.3 50 nM 1:200
100 nM 0.2 100 nM 1:100
300 nM 0.1 300 nM 1:33
500 nM 0.08 500 nM 1:20
1 µM 0.05 1 µM 1:10
2.5 µM 0.02 2.5 µM 1:4

Qeyd: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

Əlaqə

Dynamic Biosensors GmbH
Perchtinger Str. 8/10 81379 Munich, Germany

Bruker Scientific MMC
40 Manning Road, Manning Park, Billerica, MA 01821 ABŞ

www.dynamic-biosensors.com
Alətlər və çiplər Almaniyada hazırlanmış və istehsal edilmişdir. ©2025 Dynamic Biosensors GmbH Yalnız Tədqiqat İstifadəsi Üçün. Klinik diaqnostik prosedurlarda istifadə olunmur.

Tez-tez verilən suallar

What is the shelf life of the heliX cyto Normalization Solution?

Məhsulun məhdud raf ömrü var. Xüsusi məlumat üçün etiketdəki son istifadə tarixini yoxlayın.

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

Sənədlər / Resurslar

Dynamic Biosensors helix cyto Normalization Solution [pdf] İstifadəçi Təlimatı
spiral sito Normalləşdirmə Məhlulu, spiral sito, Normallaşdırma Həlli, Həll

İstinadlar

Şərh buraxın

E-poçt ünvanınız dərc olunmayacaq. Tələb olunan sahələr qeyd olunub *